Ngo Transmission, Inc.

Original Volume No. 1

 Contents / Previous / Next / Main Tariff Index



Effective Date: 11/22/2003, Docket: RP04- 67-000, Status: Effective

Original Sheet No. 65 Original Sheet No. 65 : Effective




Shipper is obligated to deliver to Transporter gas meeting the quality

specifications in the Delivering or Receiving Pipeline's tariff.




3.1 Unit of Measurement: The transportation and storage unit of gas

received and delivered by Transporter shall be a dekatherm, unless

otherwise indicated in this tariff.


3.2 Determination of Volume and Total Heating Value: The volume and

the total heating value of gas received and delivered by

Transporter shall be determined as follows, provided that

Transporter shall have the right, at any time, to rely on the

measurements and statements for quantities and heating values of

gas actually provided to Transporter by the Delivering and/or

Receiving Pipeline.


(a) The unit of volume, for the purpose of measurement, shall be

one (1) cubic foot of gas at a temperature of sixty (60)

degrees Fahrenheit, and at a pressure of thirty-three

hundredths (.33) pounds per square inch above an assumed

atmospheric pressure of fourteen and four tenths (14.4)

pounds per square inch (fourteen and seventy-three

hundredths (14.73) pounds per square inch absolute pressure)

and dry. For gas volumes reported in cubic meters, the

standard conditions are 101.325 kPa, 15 degrees C, and dry.


(b) The total heating value of the gas per cubic foot shall be

as determined by the Delivering Pipeline.


(c) Dekatherms delivered shall be determined by multiplying the

Mcf delivered by the ratio of the total heating value of the

gas delivered to 1,000. For purposes of this determination

the specific gravity and heating value shall be determined

at approximately the same time.


(d) The temperature of the gas passing through the meters shall

be determined by a temperature transducer, another type of

electronic temperature recording device, a recording

thermometer, or any other method mutually agreed upon, so

installed that it may properly record the temperature of the

gas flowing through the meters.