K N Interstate Gas Transmission Co.

Second Revised Volume No. 1-B

Effective Date: 11/01/1994, Docket: RP94-397-000, Status: Effective

First Revised Sheet No. 14 First Revised Sheet No. 14 : Superseded

Superseding: Original Sheet No. 14

GENERAL TERMS AND CONDITIONS FOR SERVICES - continued

b. If gas tendered fails to meet the specifications of this

Agreement, the measuring Party shall notify the other Party of

such failure. The receiving Party may refuse to accept such

gas. The Party tendering non-specification gas shall

indemnify the receiving Party for any injury, damage, loss, or

liability caused by the delivery of such gas, except to the

extent the receiving Party knowingly and willingly accepts

such non-specification gas.

5. MEASUREMENTS.

5.1 The unit of volume for the purpose of measurement and for the

determination of total heating value shall be the cubic foot of gas

as defined in Section 2 above. Volumes of gas measured at

prevailing meter pressures and temperatures shall be corrected to

the unit of volume defined above by the procedures described

hereinbelow.

a. Orifice Meters: Installation of orifice meters and the

determination of volumes delivered through orifice meters

shall conform to the recommendations in "Gas Measurement

Committee Report Number Three" of the American Gas Association

as amended, revised or superseded from time to time.

b. Turbine Meters: Installation of turbine meters and the

determination of volumes delivered through turbine meters

shall conform to the recommendations in "Transmission

Measurement Committee Report Number Seven" of the American Gas

Association as amended, revised or superseded from time to

time.

c. Positive Displacement Meters: Installation of positive

displacement meters and the determination of volumes delivered

through such meters shall conform to the recommendations in

"Gas Measurement Manual Displacement Measurement Part Number

Two" of the American Gas Association as amended, revised or

superseded from time to time.