K N Wattenberg Transmission LLC

Original Volume No. 1

Effective Date: 04/01/1993, Docket: CP92-203-002, Status: Effective

Original Sheet No. 46 Original Sheet No. 46 : Effective

General Terms and Conditions - continued

3.1 QUALITY TESTING.

a. The Party operating the measuring equipment, shall use

approved standard methods in general use in the gas

industry and shall cause adequate tests to be made to

determine the quality of the gas delivered hereunder.

Such tests shall be made frequently enough to insure that

the gas conforms to the specifications hereof.

b. If gas tendered to Transporter fails to meet the

specifications of this Tariff, the measuring Party shall

notify the other Party of such failure. The receiving

Party may refuse to accept such gas. The Party tendering

non-specification gas hereunder shall indemnify the

receiving Party for any injury, damage, loss, or liability

caused by the delivery of such gas, except to the extent

the receiving Party knowingly and willingly accepts such

non-specification gas.

4. MEASUREMENTS.

a. The unit of volume for the purpose of measurement and for

the determination of total heating value shall be the

cubic foot of gas as defined in this Tariff. Volumes of

gas measured at prevailing meter pressures and

temperatures shall be corrected to the unit of volume

defined above by the procedures described below:

(1) Orifice Meters: Installation and the determination

of volumes delivered through orifice meters shall

conform to the recommendations in "Gas Measurement

Committee Report Number Three" of the American Gas

Association as amended, revised or superseded from

time to time. Values of the orifice thermal expansion

factor, manometer factor and gauge location factor

shall be assumed to be unity.