K N Wattenberg Transmission LLC

First Revised Volume No. 1

Effective Date: 05/22/1998, Docket: RP98-192-000, Status: Effective

Original Sheet No. 46 Original Sheet No. 46 : Effective

General Terms and Conditions - continued

3.1 QUALITY TESTING.

a. The Party operating the measuring equipment, shall use

approved standard methods in general use in the gas

industry and shall cause adequate tests to be made to

determine the quality of the gas delivered hereunder.

Such tests shall be made frequently enough to insure

that the gas conforms to the specifications hereof.

b. If gas tendered to Transporter fails to meet the

specifications of this Tariff, the measuring Party

shall notify the other Party of such failure. The

receiving Party may refuse to accept such gas. The

Party tendering non-specification gas hereunder shall

indemnify the receiving Party for any injury, damage,

loss, or liability caused by the delivery of such gas,

except to the extent the receiving Party knowingly and

willingly accepts such non-specification gas.

4. MEASUREMENTS.

a. The unit of volume for the purpose of measurement and for the

determination of total heating value shall be the cubic foot

of gas as defined in this Tariff. Volumes of gas measured at

prevailing meter pressures and temperatures shall be

corrected to the unit of volume defined above by the

procedures described below:

(1) Orifice Meters: Installation and the

determination of volumes delivered through orifice

meters shall conform to the recommendations in

"Gas Measurement Committee Report Number Three" of

the American Gas Association as amended, Revised

or superseded from time to time. Values of the

orifice thermal expansion factor, manometer factor

and gauge location factor shall be assumed to be

unity.