Total Peaking Services, L. L. C.

Original Volume No. 1

 Contents / Previous / Next / Main Tariff Index

Effective Date: 12/19/2000, Docket: RP01-175-002, Status: Effective

2nd Revised Sheet No. 82 2nd Revised Sheet No. 82 : Effective

Superseding: First Revised Sheet No. 82

GENERAL TERMS AND CONDITIONS

(Continued)

20. MAXIMUM DAILY VOLUMES

20.1 Total Peaking shall endeavor to liquefy, vaporize, inject,

and withdraw on any day as much of each firm Customer's nomination for

such day as plant operating conditions permit. If, however, on any

day, the total of all firm Customers' nominations exceed the liquefaction,

vaporization, injection, or withdrawal capacity of the plant, then the

nominations will be allocated based on each firm Customer's proportionate

share of the total applicable capacity, but each firm Customer shall not be

allocated less than its Maximum Daily Liquefaction Volume, Maximum Daily

Vaporization Volume, Maximum Daily Injection Volume, or Maximum Daily

Withdrawal Volume, unless caused by a force majeure event as provided

in Section 16 of the General Terms and Conditions.

20.2 Total Peaking shall be obligated to accept gas for liquefaction in accordance

with the above procedure only when Customer's Storage Volume is less than

Customer's Maximum Contract Storage Capacity.

21. PENALTIES

RESERVED

22. FUEL REIMBURSEMENT

22.1 Categories of Fuel Usage. The two general categories of fuel

usage are: (1) Direct Fuel Usage, consisting of (a)

compression fuel, (b) dehydration fuel, and (c) line heating

fuel; and (2)Indirect Fuel Usage, consisting of fuel that is

consumed on site to (a) generate electricity, (b) heat facility

(if any), and (c) lost and unaccounted for volumes to the extent

required for the operation and maintenance of Total Peaking's gas

storage facilities.

22.2 Fuel Reimbursement. Fuel Reimbursement shall be calculated

separately for each service. Each Fuel Reimbursement

charge shall be negotiated by Total Peaking and Customer

such that reimbursement of fuel may be paid in kind as set

forth in Customer's service agreement(s).