ANR Storage Company

Original Volume No. 1

 Contents / Previous / Next / Main Tariff Index

 

 

Effective Date: 11/01/2007, Docket: RP08- 16-000, Status: Effective

First Revised Sheet No. 139 First Revised Sheet No. 139 : Effective

Superseding: Original Sheet No. 139

 

 

GENERAL TERMS AND CONDITIONS

(Continued)

 

 

and the parties shall then cooperate to secure a prompt

verification of the accuracy of such equipment.

Transportation and related expenses involved in the

testing of meters shall be borne by the party incurring

such expenses.

 

The Operator, for purposes of this section, shall be the

owner of the equipment referenced herein, or the agent

of such owner, or such other person as the parties may

agree in writing.

 

If, upon any test, Operator's measuring equipment is

found to be in error, such errors shall be taken into

account in a practical manner in computing the

deliveries. If the resultant aggregate error in the

computed receipts or deliveries is not more than 0.5%

for chromatograph or calorimeter and two percent (2%)

for other measuring equipment, then previous receipts or

deliveries shall be considered accurate. All equipment

shall, in any case, be adjusted at the time of test to

record correctly. If, however, the resultant aggregate

error in computing receipts or deliveries exceeds 0.5%

for chromatograph or calorimeter and two percent (2%)

for other measuring equipment, at a recording

corresponding to the average hourly rate, of Gas flow

rate for the period since the last preceding test, the

previous recordings of such equipment shall be corrected

to zero error for any period which is known definitely

or agreed upon, such correction shall be for a period

extending over one-half of the time elapsed since the

date of the last test.

 

6.4 In the event any measuring equipment is out of service,

or is found registering inaccurately and the error is

not determinable by test, previous recordings of

injections or withdrawals through such equipment shall

be determined as follows; provided, however, that the

correction period shall not exceed one (1) year:

 

(a) by using the registration of any check meter or

meters if installed and accurately registering, or

in the absence of (a);

 

(b) by correcting the error if the percentage of error

is ascertainable by calibration, special test or

mathematical calculation, or in the absence of

both (a) and (b) then;