White River Hub, LLC

Original Volume No. 1

 Contents / Previous / Next / Main Tariff Index

Effective Date: 11/01/2008, Docket: RP08-645-000, Status: Effective

Original Sheet No. 130 Original Sheet No. 130

GENERAL TERMS AND CONDITIONS

(Continued)

(c) The measurement equipment of the operator of the

interconnecting facility will be for check purposes only and, except as

expressly provided in these General Terms and Conditions, will not be used in

the custody measurement of gas.

14.11 Calibration and Test of Measurement Equipment. White River will

verify the accuracy of all measurement equipment at reasonable intervals.

White River will provide notice of regular inspections and calibrations of

measurement equipment and any routine orifice plate changes to the operators

of interconnecting facilities, and the operators or other contractually

designated representative of Shippers may attend the inspections or plate

changes. White River shall not be required to verify the accuracy of its

equipment more frequently than once in a 90-day period. In the event an

operator of an interconnecting facility or their contractually designated

representative notifies White River that it desires a special test of any of

White River's measurement equipment, the parties shall cooperate to secure

prompt verification of the accuracy of such equipment. Any operator of an

interconnecting facility or their contractually designated representative

requesting such a special test of White River's measurement equipment shall

bear White River's out-of-pocket costs of the test if the equipment is found

to be accurate within one percent (1%).

14.12 Correction of Measurement Errors. If any measurement equipment is

found to be inaccurate, the equipment will be adjusted immediately to measure

accurately. If the measurement equipment in the aggregate is found to be

inaccurate by one percent (1%) or more at a recording corresponding to the

average hourly rate of gas flow for the period since the last preceding test,

any payments based upon inaccurate measurement will be corrected at the rate

of such inaccuracy for any period that is known definitely or agreed upon. In

the case where the period is not known or agreed upon, such correction will be

for a period extending over one half of the time elapsed since the date of the

last test.