Williston Basin Interstate Pipeline Co.

Second Revised Volume No. 1

 Contents / Previous / Next / Main Tariff Index

Effective Date: 12/17/2007, Docket: RP08- 68-000, Status: Effective

Fourth Revised Sheet No. 291 Fourth Revised Sheet No. 291 : Effective

Superseding: Third Revised Sheet No. 291

GENERAL TERMS AND CONDITIONS (Continued)

24. PIPELINE SERVICE OBLIGATIONS (Continued)

obligation under the Service Agreement shall be automatically

abandoned upon expiration of the Service Agreement.

24.2.3 For firm Service Agreements with a term of less than one

(1) year: Transporter may exercise its right of pregranted

automatic abandonment upon expiration of the Service Agreement and

there shall be no right of first refusal or rollover, unless

agreed to in writing in the original Service Agreement executed by

Shipper and Transporter.

24.2.4 For interruptible Service Agreements: Transporter may

exercise its right of pregranted automatic abandonment upon

expiration of the Service Agreement and there shall be no right of

rollover unless agreed to in writing in the original Service

Agreement executed by Shipper and Transporter.

24.3 The right of first refusal shall be applicable only to service

at the maximum rate under a firm Service Agreement with a term of at

least 12 months of consecutive service, except that a maximum rate

contract for more than one year, for a service which is not available

for 12 consecutive months, would be subject to the right of first

refusal.

24.3.1 Service Agreements which include negotiated (except as

described in Subsection 51.4 of these General Terms and

Conditions), seasonal (except as described in Subsection 24.3),

limited term service (except as described in Subsections 10.5 and

10.6) and/or discounted rates shall not be eligible for the right

of first refusal.

24.4 To exercise the right of first refusal so as to avoid pregranted

automatic abandonment as discussed in this Section 24, firm service

Shippers falling into the categories defined by Subsections 24.2.1,

24.2.2 and 24.3 shall use the following procedures: