Kinder Morgan Interstate Gas Transmission LLC

Fourth Revised Volume No. 1-B

Effective Date: 06/17/2001, Docket: RP01-422-000, Status: Effective

First Revised Sheet No. 14 First Revised Sheet No. 14 : Effective

Superseding: Original Sheet No. 14

GENERAL TERMS AND CONDITIONS FOR SERVICES - continued

4.2 QUALITY TESTING

a. The Party operating the measuring equipment shall use

approved standard methods in general use in the gas industry, and

shall cause adequate tests to be made to determine the quality of

the gas delivered. Such tests shall be made at intervals frequent

enough that the gas conforms to these specifications.

b. If gas tendered fails to meet the specifications of this

Agreement, the measuring Party shall notify the other Party of

such failure. The receiving Party may refuse to accept such gas.

The Party tendering non-specification gas shall indemnify the

receiving Party for any injury, damage, loss, or liability caused

by the delivery of such gas, except to the extent the receiving

Party knowingly and willingly accepts such non-specification gas.

5. MEASUREMENTS.

5.1 The unit of volume for the purpose of measurement and for the

determination of total heating value shall be the cubic foot of gas as

defined in Section 2 above. Volumes of gas measured at prevailing meter

pressures and temperatures shall be corrected to the unit of volume

defined above by the procedures described herein below.

a. Orifice Meters: Installation of orifice meters and the

determination of volumes delivered through orifice meters shall

conform to the recommendations in "Gas Measurement Committee

Report Number Three" of the American Gas Association as amended,

revised or superseded from time to time.

b. Turbine Meters: Installation of turbine meters and the

determination of volumes delivered through turbine meters shall

conform to the recommendations in "Transmission Measurement

Committee Report Number Seven" of the American Gas Association as

amended, revised or superseded from time to time.