Venice Gathering System, L. L. C.

Original Volume No. 1

 Contents / Previous / Next / Main Tariff Index

Effective Date: 01/01/1998, Docket: CP97-533-002, Status: Effective

Original Sheet No. 168 Original Sheet No. 168 : Effective

GENERAL TERMS AND CONDITIONS

(Continued)

b. Error Correction, < 1.0%: If, during any

test of the measuring equipment, an

adjustment or calibration error is found

which results in an incremental

adjustment to the calculated hourly flow

rate which does not exceed the one

percent (1.0%) limit as described in part

(a) of this Section, or if the total

measurement adjustment during a Month is

less than 500 MMBTU, all prior recording

shall be considered to be accurate for

quantity determination purposes. Any

measuring equipment found to be measuring

inaccurately in any percentage shall be

adjusted at once to read accurately.

17.7 Special Test

In the event Shipper desires a Special Test (a test

not scheduled by Measuring Party under the provisions of

Section 17.4 above) of any measuring equipment, reasonable

advance notice, in writing, shall be given to Measuring

Party and both parties shall cooperate to secure a prompt

test of the accuracy of such equipment. If the measuring

equipment falls within the accuracy provisions of Section

17.6 above, and if the measurement equipment meets all

appropriate specifications of Section 17.8, Shipper shall

bear the cost of such Special Test. If the measuring

equipment does not fall within the accuracy provisions of

Section 17.6 above, or if the measurement equipment does not

meet all appropriate specifications of Section 17.8,

Measuring Party shall bear the cost of such Special Test,

and Measuring Party shall also bear the costs to promptly

repair or replace the defective equipment.