El Paso Natural Gas Company
Second Revised Volume No. 1A
Contents / Previous / Next / Main Tariff Index
Effective Date: 04/01/2010, Docket: RP10-454-001, Status: Effective
Sixth Revised Sheet No. 238 Sixth Revised Sheet No. 238
Superseding: Fifth Revised Sheet No. 238
TRANSPORTATION GENERAL TERMS AND CONDITIONS (Continued)
6. NOMINATIONS AND SCHEDULING PROCEDURES (Continued)
6.2 Capacity Allocation Procedure (Continued)
(a) Firm Allocation (Continued)
(iii) All other firm transportation Shippers utilizing Flow
Point Secondary, Flow Path Secondary or Alternate
Capacity (including Segmentation) in the order listed
below. Capacity within each category shall be
scheduled within each group first to those shippers
paying the maximum tariff rates for any rate zone.
For scheduling priority purposes only, Short-Term
Rates that exceed the related maximum Long-Term Rates
will be deemed equivalent to maximum Long-Term Rates.
If allocations are required among the maximum rate
shippers, they will be performed on a pro rata basis
using contract MDQ. Service will be scheduled next to
those shippers paying discounted rates with the
highest reservation rates being scheduled first. If
allocations are required among discounted rate
shippers paying the same discounted rate, they will be
performed on a pro rata basis using contract MDQ.
(A) Firm Shippers using Flow Point Secondary Capacity.
(B) Firm Shippers using Flow Path Secondary Capacity.
(C) Firm Shippers using First Alternate Capacity.
(D) Firm Shippers using Second Alternate Capacity.
(iv) Service using Flow Point Secondary, Flow Path
Secondary, First Alternate, or Second Alternate
Capacity will be scheduled within each group for
capacity allocations at Delivery Points or along a
Flow Path. For purposes of allocating such capacity,
the following shall apply:
(A) Confirmed nominations shall be used to determine
capacity allocations, if any, at Flow Point
Secondary, First Alternate, and Second Alternate
points.
(B) When there is a constraint along a Flow Path, the
confirmed nominated quantity at or through the
constraint shall be used to determine capacity
allocations at or through such constraint when the
Flow Path scheduling priority assigned at the
constraint location is Flow Path Secondary, First
Alternate or Second Alternate.