Crossroads Pipeline Company

First Revised Volume No. 1

Effective Date: 11/01/2001, Docket: RP02- 14-000, Status: Effective

Original Sheet No. 248 Original Sheet No. 248 : Effective

GENERAL TERMS AND CONDITIONS

(Continued)

(j) Other types of meters may be used if mutually agreed to by Transporter and Shipper.

(k) Instrumentation and equipment to provide Records or samples of gas necessary to determine the

specific gravity, heating value, and/or concentrations of nitrogen or carbon dioxide as required under

Sections 26.6, 26.7 and 26.8 hereof may be installed at representative points along the pipeline in lieu of

installing such instrumentation and equipment at each measuring station.

(l) Upon notice to Shippers, Transporter may prospectively implement and use any future editions

or versions of the American Gas Association or ANSI reports referenced in this Section 26.

(m) Nothing in this Section 26.9 shall be construed to require Transporter to construct any

facilities.

26.10 Check Measuring Equipment.

(a) Shipper may install check measurement equipment, provided such equipment does not interfere

with the exercise of Transporter's rights to operate its station under this Tariff.

(b) Transporter, in the presence of Shipper, shall have access to Shipper's check measuring

equipment at all reasonable times, but the reading, calibration and adjustment thereof and the change of

charts shall be performed only by Shipper, unless otherwise agreed upon.

equipment so as to avoid any inaccuracy in the determination of the quantity of gas delivered.

(d) The Records from such check measuring equipment shall remain the property of Shipper, but

upon request Shipper will submit to Transporter its Records and charts, together with calculations

therefrom, for inspection, subject to return within 30 days after receipt thereof.

26.11 Calibration and Testing of Meters. The accuracy of all measuring equipment shall be verified by its

operator at reasonable intervals and, if requested, in the presence of representatives of the other party,

but neither Transporter nor Shipper shall be required to verify the accuracy of such equipment more

frequently than once in any 30-day period. If either party at any time desires a special test of any

measuring equipment, or if either party at any time observes an error in any such measuring equipment, it

will promptly notify the other party, and the parties shall then cooperate to secure a prompt verification

of the accuracy of such equipment. The expense of any such special test shall be borne by the requesting

party if the measurement equipment so tested is found not to be in error such that previous Recordings from

the equipment must be corrected under the provisions of Section 26.12 herein.