Crossroads Pipeline Company
First Revised Volume No. 1
Contents / Previous / Next / Main Tariff Index
Effective Date: 09/01/2005, Docket: RP05-435-000, Status: Effective
Second Revised Sheet No. 46 Second Revised Sheet No. 46 : Effective
Superseding: First Revised Sheet No. 46
GENERAL TERMS AND CONDITIONS
1.7 "Cubic Foot" and "Standard Cubic Foot" shall mean that quantity of
natural gas that occupies one cubic foot of volume at the Volumetric
Measurement Base defined in Section 26.2 of the General Terms and
1.8 "Designated site" shall mean the electronic address used to contact
an entity for EDI transmission.
1.9 "Dth (Dekatherm)" shall mean one million Btu. The standard quantity
for nominations, confirmation and scheduling is dekatherms per gas day in
the United States, and gigajoules per gas day in Canada and gigacalories
per gas day in Mexico. (For reference 1 dekatherm = 1,000,000 Btu's; and 1
gigajoule = 1,000,000,000 joules; and 1 gigacalorie = 1,000,000,000
calories.) For commercial purposes, the standard conversion factor between
dekatherms and gigajoules is 1.055056 gigajoules per dekatherm and between
dekatherms and gigacalories is 0.251996 gigacalories per dekatherm. The
standard Btu is the International Btu, which is also called the Btu(IT);
the standard joule is the joule specified in the SI system of units.
1.10 "Electronic Bulletin Board" and "EBB" shall mean Transporter's
computerized system for the posting, sending and receiving of notices and
other communications under this Tariff.
1.11 "EDI" shall mean electronic data interchange as defined by the
standards established by the GISB and approved by the Commission, or
Transporter defined data sets where no GISB standard exists.
1.12 "Elapsed-Prorata-Capacity" shall mean that portion of the capacity
that would have theoretically been available for use prior to the effective
time of the intraday recall based upon a cumulative uniform hourly use of
1.13 "Elapsed-prorated-scheduled quantity" shall mean that portion of the
scheduled quantity that would have theoretically flowed up to the effective
time of the intraday nomination being confirmed, based upon a cumulative
uniform hourly quantity for each nomination period affected.
1.14 "Electronic Measurement" shall mean that form of measurement
consisting of flow computers or computerized Remote Terminal Units (RTUs),
electronic transducers, and associated power, data communications, and
other electronic equipment to accomplish the measurement of gas and
transfer of data without the use of charts or other paper Recordings.