Chandeleur Pipe Line Company

Second Revised Volume No. 1

 Contents / Previous / Next / Main Tariff Index

Effective Date: 06/01/1997, Docket: RP97-197-001, Status: Effective

First Revised Sheet No. 21 First Revised Sheet No. 21 : Effective

Superseding: Original Sheet No. 21

GENERAL TERMS

AND CONDITIONS

3.0 GAS MEASUREMENT (Cont'd)

3.1 Measurement Equipment (cont'd)

(c) Inspection and Testing

(1) In addition to the regular inspection of

measurement equipment required by the

current edition of the U.S. Geological

Survey's Outer Continental Shelf Order

No. 13, including any supplements

thereto and successive issues hereof,

the meters, instruments and equipment

installed by either Party shall be

subject to inspection by the other at

all reasonable times, and either Party

may request that a test be made of the

other's meters or instruments. If the

percentage of inaccuracy of the

equipment in question shall be found to

be less than 2%, then no correction of

previous reading shall be made for the

period since the last test.

(2) If upon any test the percentage of

inaccuracy of any metering equipment is

found to be in excess of 2%, previous

readings of such equipment shall be

corrected for any period which is

definitely known or agreed upon, but in

case such period is not so known or

agreed upon, such correction shall be

made for a period covering the last half

of the period since the last test.

(d) Failure of Measuring Equipment

If for any reason meters are out of service

or out of repair so that the amount of

Gas delivered cannot be ascertained or

computed from the readings thereof, the

amount of Gas delivered during such period

shall be estimated and agreed upon by the

use of the first of the following methods

which is feasible:

(1) By correcting the error if the

percentage of error is ascertainable by

calibration, test or mathematical

calculation; or