Blue Lake Gas Storage Company

First Revised Volume No. 1

 Contents / Previous / Next / Main Tariff Index

 

 

Effective Date: 08/01/1993, Docket: RS92- 93-001, Status: Effective

Original Sheet No. 135 Original Sheet No. 135 : Effective

 

 

GENERAL TERMS AND CONDITIONS

(Continued)

 

4.7 Reduction in Maximum Storage Quantity. In the event that

Customer nominates or utilizes less than 50% of its Maximum

Storage Quantity under Rate Schedule IS for a period of one

(1) year, Seller may reduce Customer's Maximum Storage

Quantity to 125% of the average utilization during such year,

which new Maximum Storage Quantity, as applicable, shall be

effective on the first Day of the Month following the Month in

which Seller gives Customer notice of such reduction.

 

5. PRESSURE AT POINT OF INJECTION/WITHDRAWAL

 

5.1 Pressure at Point of Injection/Withdrawal. Unless otherwise

agreed to by the parties as set forth in the Service

Agreement, Customer shall cause the Gas to be delivered at the

Point of Injection/Withdrawal at a pressure sufficient to

allow the Gas to enter Seller's system at the varying

pressures that may exist in such system from time to time;

provided, however, that such pressure of the Gas delivered or

caused to be delivered by Customer shall not exceed the

Maximum Allowable Operating Pressure ("MAOP") which Seller

specifies for the Point of Injection/Withdrawal. In the event

the MAOP of Seller's system, at the Point of

Injection/Withdrawal hereunder, is from time to time increased

or decreased, then the MAOP of the Gas delivered or caused to

be delivered by Customer to Seller at the Point of

Injection/Withdrawal shall be correspondingly increased or

decreased upon notification by Seller to Customer.

 

Unless otherwise agreed to by the parties as set forth in the

Service Agreement, Seller shall Tender the Gas to or for the

account of Customer at the Point of Injection/Withdrawal

hereunder at Seller's prevailing line pressure as such may

vary from time to time.

 

6. MEASUREMENT AND MEASUREMENT EQUIPMENT

 

6.1(a) The volume of Gas delivered to Seller hereunder or

redelivered to or for the account of Customer hereunder

shall be measured by:

 

(1) An orifice meter, designed, installed maintained and

operated as recommended in the latest issue of American

National Standard ANSI/API 2530 (American Gas Association

Gas Measurement Report No. 3), entitled "Orifice Metering